Using the products of this project, we will explain to you in this project how to create PWM signals using ESP32 with Arduino IDE. For example, we’ll build a simple circuit that dims an LED using the ESP32’s PWM LED controller. We’ll also show you how you can get the same PWM signal on different GPIOs at the same time.
The kit contains the following ingredients:
1 x ESP32 development board WIFI Bluetooth | ||
3 x Red LED | ||
3 x 220 Ohm Resistor | ||
1 x MB102 830 Tie Points High Quality Solderless Breadboard | ||
10 x Male to Male jumper wires | ||
10 x Male to Female jumper wires |
Reviews
There are no reviews yet.