L298N Dual H Bridge DC/Stepper Motor Driver Controller Module

Availability:

2 in stock


QUICK OVERVIEW

  1. Driver chip: L298N Dual H Bridge
  2. Supply voltage: VMS 5V – 35V
  3. Peak current IO: 2A per bridge
  4. Max power consumption: 20W
  5. Provides 4 LEDs that reflect the state of the control logic
  6. Independent direction, speed, and braking for each motor

37.0 ر.س

2 in stock

This motor driver for DC Motors and Stepper Motor is widely popular because it uses the famous L298N Dual H Bridge Driver Chip. This motor driver is optimized for maximum performance at a cost everyone can afford.

The L298N Dual H Bridge DC/Stepper Motor Driver Controller Module is for driving two robot motors. It uses the popular L298N Dual H-Bridge Motor Driver chip and is powerful enough to drive motors from 5-35 Volts at up to 2 Amps per channel. The flexible digital input controls allow each motor to be fully independent with complete control over speed direction and braking action.

This board provides a handy 5V regulator that can be used to power other circuitry such as your robot’s microcontroller. Its modular design is easily adapted to a wide variety of robot controllers including the popular Arduino family.

This L298N driver module adopts the original brand new L298N chip from ST company. It uses the SMT process and high-quality aluminum electrolytic capacitor to stabilize the circuit. The module can easily control the DC motor speed and direction, also control the 2 phase stepper motor.


Features :

  1. Popular L298N Dual H-Bridge Motor Driver chip
  2. Drivers motors from 5-35V at up to 2A per channel
  3. Provides 4 LEDs that reflect the state of the control logic
  4. Independent direction, speed, and braking for each motor
  5. Screw terminals for easy connections to motors and power
  6. Includes a heavy-duty heat sink for maximum performance
  7. Easy to interface with most robot controllers
  8. Supports current sensing
  9. Handy power LED

Package Includes :

1 x L298N Dual H Bridge DC Stepper Motor Driver Controller Module

SKU: AA035 Category:
Driver Chip L298N
Supply Voltage (V) 5 to 35
Supply Current (A) 2 (peak per channel)
Logic Voltage (V) 4.5 to 5.5
Logic Current (mA) 0 to 36
Control signal input voltage (V) 4.5 to 5.5
Maximum Power (W) 20
Operating Temperature (°C) -25 to +130
Length (mm) 55
Width (mm) 60
Height (mm) 30
Weight (gm) 35
Shipment Weight 0.135 kg
Shipment Dimensions 6 × 6.5 × 4 cm

Based on 0 reviews

0.0 overall
0
0
0
0
0

Be the first to review “L298N Dual H Bridge DC/Stepper Motor Driver Controller Module”



There are no reviews yet.

SHOPPING CART

close
[]